Zebra LP 2824

Posted by MOI on March 26, 2006, 6:08 pm

Please log in for more thread options

I am new to the barcode printer setup process and would appreciate some basic
help in setting it up. I have RMS 1.3 and installing Zebra LP 2824 using USB
port.

I installed the Generic/Text drivers and then connected the printer via USB
port. To test it was working I went into Label wizard and tried printing a
sample label by selecting Zebra 4"x3" (the only option available for zebra).
Ultimately I would be using 1.25"x1" label size but just to test that
everything was working properly I have test label stock 2.25" x 4" in the
printer. Unfortunately the Zebra printer is not printing anything. Any tips?

Also, if I were to redesign/recreate a label in do I have to install Zebra
software?

Thx for your assistance.

Posted by billr3 on March 26, 2006, 6:07 pm

Please log in for more thread options

I forgot to mention tha tI was also using a USB initially and tech support
had me switch because it is easy to be using the wrong port using USB. That
was when i was not printing at all.
--
billr

"MOI" wrote:

> I am new to the barcode printer setup process and would appreciate some basic

> help in setting it up. I have RMS 1.3 and installing Zebra LP 2824 using USB

> port.

> I installed the Generic/Text drivers and then connected the printer via USB

> port. To test it was working I went into Label wizard and tried printing a

> sample label by selecting Zebra 4"x3" (the only option available for zebra).

> Ultimately I would be using 1.25"x1" label size but just to test that

> everything was working properly I have test label stock 2.25" x 4" in the

> printer. Unfortunately the Zebra printer is not printing anything. Any tips?

> Also, if I were to redesign/recreate a label in do I have to install Zebra

> software?

> Thx for your assistance.